Custom Printed Hydro Dipping Film 45 cm

Hydro dipping film with a custom print.

Width: 45 cm

Length: 100 cm per unit (example: 3 units = 300 cm)

Packaging and shipping: the film is rolled up and placed in a plastic bag that protects it from moisture and dirt, with silica gel sachets for extra protection. Everything ships in a reusable cardboard tube with plastic caps.

Special instructions for use:

1. Unroll the film on a dry table.
2. Peel the film off its backing.
3. Place the side that was stuck to the backing in contact with the water.
4. Wait 60 seconds for the film to hydrate, with the water at 25 ºC.
5. Apply one pass of activator, using less than with a standard hydro dipping film.
6. Wait 20 seconds until the film has fully liquefied.
7. Dip the part more slowly than with a standard hydro dipping film and keep the film from stretching: always move the part towards the film, not the other way round.